Interested to Buy Any Domain ? << Click Here >> for more details...
why Transformers power mentioned in KVA?. and why Generators
and Motors power mentioned in KW?.
- 10 Answers
- 14503 Views
- I also Faced
- E-Mail Answers
Answer Posted / mani_mc2006
iam not sure. but my answer is Transformer not having load
variation. but Generators and motors having load variation.
so power factor will not be constant. That's why mentioned
like this.
| Is This Answer Correct ? | 3 Yes | 18 No |
Post New Answer View All Answers
Advantages/Disadvantages of earthing of neutral bus on MSB instead of separate neutral earthing for transformer/DG sets feeding to MSB
what is the effect of power factor of machines in starting current
where the lexical paramater will use in fron end?
why not starting switch first connect in direct on line starter?????
IF HT CAPACITOR IN ON POSITION IS THERE ANY LOSSES I.S I SQURE OCCURS IN THE SYSTEM
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
Refernce currents are to be generated using refernce cueernts how can this be done??
why ten delta testing is carried out on power transformer
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
why i can not use thimble on capacitor duty contactor
how to calculate the capacitor to maintain power factor?
we are having 15kw and 3kw motor both can run in same time , instead of using copper we are using ug aluminium cable , 35 sq.mm is suitable for its current carrying capacity..?
On what cycle does thermal power plant operate?
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
