Interested to Buy Any Domain ? << Click Here >> for more details...
what is pt100 RTD, and does 100 stands for
- 8 Answers
- 42872 Views
- Tata Power, I also Faced
- E-Mail Answers
Answer Posted / guest
platinum 100 type rtd. 100 stands for resistance(i.e 100
ohms).We set 0 temperature for resi 100 ex range 0 to
200degcel. then 0 degree is for 100 ohm resistance.(min set
value)
| Is This Answer Correct ? | 39 Yes | 3 No |
Post New Answer View All Answers
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
what is loop1 and loop2 in MTS LT?
Q- What are the application in which PNP transistor is preferred over NPN ?
can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
When doing a liquid seal on a differential flow transmitter , most of the time the sealing liquid will be heavier then the process fluid. For wich application will the sealing liquid be lighter than the process fluid if transmitter is mounted below the process line.
diff between neutral ,ground,phase , earthing and shielding?
how to calculate range of level transmitter?
what is the diffrence between pressure safety valve & pressure relief valve....pls
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
which type of zones used for boiler? & why ?
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
Which tank weighing system is better to install (Accuracy point of view) 1) Tank weighing system with 3 load cell or 2) Tank weighing system with 4 Load cell
