Why DP transmitters are subjected to high static pressure
test of 100 bar. Though they will be used for very small
pressure range
- 4 Answers
- 8447 Views
- HPCL, I also Faced
- E-Mail Answers
Answer Posted / mhakave rajesh
it's span of measurement may be less eg 0- 5 bar,but
pressure acting on single side either of hp or lp (i.e.
process side pressure) may be high, so to check zero of tx
at such operating pressure it is........ so and so.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
How does your previous experience relate to the job you are applying for ?
What is heating effect?
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
components of control circuit belongs to control valve
why we use the ac supply load cell>?can we use the dc supply load cell?advantages and disadvantage of the ac supply load cell?
How ejector(or)evactor air pump is working in thermal power plant?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
Can I calibrate the Electromagnetic Flow Meter on line and How.
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
How to Calibrate Level Switch in field
