Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dhaval patel
While in line, if the CT terminals get open, it can result
in heavy faults in CT core. To prevent developing of such
higher voltage at the secondary terminals of the CT, it
shall be protected.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
What is the universal motor?
What do you mean by phasors?
State the factors, for the choice of electrical system for an aero turbine.
What are the different sign conventions used in electric circuits?
Given a collection of points P in the plane, a 1-set is a point in P that can be separated from the rest by a line; i.e. the point lies on one side of the line while the others lie on the other side. The number of 1-sets of P is denoted by n1(P). The maximum value of n1(P) over all configurations P of 19 points in the plane is 18
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
which book to refer in electrical engineering for iocl exam & which book for general english.
should %impedance be high or low in a power transformer? if so why?
Can we use shunt trip coil instead of trip coil with protection relay for protection?
reason of diode failure in alternator
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
IF I KNOW THE AREA OF CROSS SECTION OFTHE WIRE , WATTAGE OF THE LOAD ,VOLTAGE SUPPLY WHAT IM GIVING TO THE LOAD AND ALSO POWER FACTOR OF LOAD ....... SO GIVE ME FOR WHAT AMOUNT OF CURRENT I SHOULD USE WHICH TYPE OF CABLE?
full form of flry b
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
