We have one Energy meter for Measuring the
voltage,current,power,energy(KWH,KVARH,KVAH) & power
factor.The problem is that the meter does not show whether
the PF is lagging or leading.So i want to know that is
there any way or calculation to find out that whether the
PF sign (lagging or leading) depending upon the above
mentioned parameters?
Answer Posted / ram
please check the meter must be indicating sign as +
(leading) or - (Lagging) power factor.
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
ult of expression 'document.FrmQF.myem
I NEED RRB APTITUDE QUESTIONS AND MODEL PAPER,PLEASE SEND MY E-MAIL joo28_eee@yahoo.co.in
What is the HVDC Transmission System? What are the conditions applicable to lay an HVDC Line?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
Does the motor power displayed on the Motor name plate is the mechnical power motor delivers or it is consumed power from the system?
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
mention hazard experienced during installation
What is the relationship between voltage,current & frequency?
How to check the cable fault / hv test of transformer cable.
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Why Ac Systems Are Preferred Over Dc Systems?
Z transform is use when system is not a) converges b) diverges
what is meant by impedance & transient protection?
l&t switch FN 63 handle position can we change