Answer Posted / ram
1. switch on the elcb. press the test button on the elcb.
it should trip.
2. switch on the elcb. connect test lamp between earth and
output phase of the elcb. the elcb should trip.
if fails in both the condition the elcb is faulty.
Is This Answer Correct ? | 33 Yes | 2 No |
Post New Answer View All Answers
what is the use of the circle diagram
does a DG set has low fault level as compared to that of a transformer.If yes then why.
What type of core material is used for metering C.T and protection C.T???
Where voltage are high and current to be interrupted is low the breaker preferred is:
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
condition Autotrip facia come on control panel of electrical transmission line?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
how we can calculate 2 phase welding transformer rating or total power?
What is open delta Xformer? It's adavntages & Use?
what is parellel power factor correction?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
Explain what is electric traction?
which types of relay used in acb and vcb?