Interested to Buy Any Domain ? << Click Here >> for more details...
What are the different protection systems takes place on
control panel board?
- 7 Answers
- 38496 Views
- BSNL, I also Faced
- E-Mail Answers
Answer Posted / khajamian
MCB,s MCCB,S .....miniature circuit breaker and mould case
circuit breaker....and various relays..... [protective
relay,current relay, thermal relay..over load relay.. ]etc
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
Why is ignitor used in sodium vapour lamp
Can you explain about pole discrepancy scheme
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
WHAT IS MEANT BY DERATING OF THYRISTOR?
what are factors to be consider to design a HT & LT motor?
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
what is Anti-pumping?
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
at meter room 50 hrc switch installed,but there are not get earthing proper,so what happen?and 11kv transformer out put going in to hrc main 400a three nog each? so earthing is require for all switch? (some customer made earthing at there home.)
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
Load break swicth maintenance procedure.
What is the necessary and sufficient condition for stability.
what is the easiest method of short circuit current calculation ? pls. derive with a mathematical example in real life application.
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
