What do you call the clearing of air inside cylinder after
combustion?
Answer Posted / pbalaji
knocking
Is This Answer Correct ? | 2 Yes | 13 No |
Post New Answer View All Answers
Which theories of failure are used for ductile materials ?
Checking points in steering gear system?
Please advise your reasons for applying for this role and why you think you are suitable?
what type of question has been asked at schwing stetter
please send me previous question papers of rrb chennai applied for junior engineer in mechanical dept
how much capacity of id fan for 200HP induction motor
Explain what are the thermal conductivity properties of brass?
all mrf company details
can anyone guide me me for engineering service commission exam?
What are the important operational performance parameters in design of fuel firing equipment ?
What is the difference between Michell type bearing and anti friction bearing and the application.
what is the effect of throttle pressure on turbine efficiency?
What is the critical speed. Compare the critical speed of hollw shaft and solid shaft.
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
Which is the common element between brass and bronze ?