Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gunnam santosh
for an induction motor at starting current is very high
speed is small so initially reduced current is applied.for
star connected winding phase voltage is root3 times the line
voltage and for delta current is root3 times the line current
so initial current can be reduced by using delta and then
star during starting of the motor
| Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
3- What is the target from Zero Impedance, Single Phase Imp., S/C Imp. and magnetic balance tests?
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
Explain about Dubai electrical sysaem? Explain about Dubai drinking water system? Explain about Dubai Burj tallest building Electrical,Water.etc.. maintenance system?
what is the difference between vector scale and vector diagram?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
Why synchronous motor is used in power factor improvement,dc series in lift
What is an ac motor?
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
what is the common earth
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
concept of busbar and load dispatching..?
How to Calculate KA Rating of Main LT Panel
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
how to maintain frenquncy with syncronising sub-station for distribution
Is there any question in the name of Static Switch in UPS??
