What is Harmonics & what are its efect & which harmonic is
dangerous
- 5 Answers
- 14609 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / gunnam santosh
harmonics are mainly produced due to leakage fluxes
basically in transformers and ac generators.these leakage
fluxes induces there respective emfs in the armature which
causes an effect on fundamental waveform and distorts the
fundamental waveforms.basically there are even as well as
odd harmonics.even means even number of positive and
negative cycles in one cycles of fundamental wave
cycles,these have zero effect as they neutralizes by
positive and negative cycles.where as odd harmonics has
major effect.basically star connected armature windings are
used to reduce odd hormincs.
and by using short pitched windings
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
Pl. brief about break-down maintenance of machine tool.
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
Define stepper motor. What is the use of stepper motor?
what & how to check the lightning arrester
How to see the inductance in a transmission lines
During underground cabling in landscape area what did we cover the cable with to prevent the electric shock & protect the cable?
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
what are the range of memory address in plc for L&T lx7 4A
when we decide to use soft starter drive or vfd drive in mcc to operate apump?
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
How can I calculate ISF of current transformer?
What do you mean by reach and reach the point of the relay?
What do you mean by power transformer?
sugest any typical project ?
