how to improve my communication skills
- 7 Answers
- 8770 Views
- Infosys, MAHINDRA, Wipro, I also Faced
- E-Mail Answers
Answer Posted / anusha
TALK WITH YOUR FRIENDS, ALSO LISTEN TO THEIR SPEECH
TALK IN AN OPENMINDED WAY
NEVER STOP,OR BLABBER SOMETHING
TALK FLUENTLY IT SHOULD COME FROM HEART
| Is This Answer Correct ? | 15 Yes | 0 No |
Post New Answer View All Answers
what is the difference between unarmoured & Flexible cable? How to identified?
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
What will happen if the voltage in my house drops from 220V to any lower voltage?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Good day everyone,currently in our premise we using 30kw slip ring motor with resistance bank which we use as forward and reverse at conveyor bar handling. So,my question is how do we calculate the resistance bank which is suit the motor. Kindly,assist me... thank you
List the advantages of star-delta starter with induction motor?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to test lightning Arrester?
Why do power lines not short out when they fall into water?
difference between high and low impedance BUS BAR relay??
I need a formula to calculate the size of cable as per load but in the terms of length. Please Reply me as i search lot of sites but i did not get the answer.
what is the function of Moulded case circuit breaker, why it is called Moulded?
11 kV line deraction check by an Engineer.
what is differant beetween overload current and phase current?
What is limitedly stable system?
