Interested to Buy Any Domain ? << Click Here >> for more details...
how to improve my communication skills
- 7 Answers
- 10640 Views
- Infosys, MAHINDRA, Wipro, I also Faced
- E-Mail Answers
Answer Posted / deepti.k.j
hey friends,first thing s too make ur mind preparation that
i should improve my communication skill then proceed
ok.first increase your reading habit and wat ever you
read,read it loudly,and so that it will improve your
vacublary and so on.. n this gives u some confident on
yourself while taking with any body. daily practice the
same thing for few days and improve your communication
skill.
| Is This Answer Correct ? | 19 Yes | 1 No |
Post New Answer View All Answers
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
what are inherent currents?
What is dc current source? Differentiate between ideal and non ideal current sources?
why industry prefer ht motor instead of lt motor.
There is air in a room . the top and bottom of the room are at constant temp. T1 and T2. DRAW THE temp profiles if a. T1 greater than T2 b. T1 less than T2
why 5kW motor becomes unbalance if its relay trip 1st time and its set value is 7.0 A
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
What is the normal phase difference between the voltage and the no-load current in a transformer?
How earthing/grounding done in aeroplanes and ships.
What is Tachometer used to measure?
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
Why in ESP Positive earthed
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
