Interested to Buy Any Domain ? << Click Here >> for more details...
give me the mix proportion for design mix concrete M10 grade
1:4:8
- 13 Answers
- 65055 Views
- Gammon, IOCL, PSL, SDG, Simplee, STUP Consultants Pvt Ltd, I also Faced
- E-Mail Answers
Answer Posted / nimmakayala
It not a design mix
It is a lean mix of proportion is 1:3:6(C:FA:CA)
| Is This Answer Correct ? | 29 Yes | 2 No |
Post New Answer View All Answers
HOW MANY BAGS OF CEMEMT USED IN PER M2 OF PARTITION WALL
4. Differentiate between NC and OC soils. Draw curves for (i) Stress vs Strain (ii) Volume charge vs Strain (iii) Pore pressure vs Strain for these soils
in plate load test what is the thickness of plate 20mm 5mm 50mm none
why +1 to be followed for calculating the no of bars in BBS. Please explain
57. Calculate the volume of a truck loaded with stone chips whose data are as follows– 5 Top Length - 13-9, 13-10, 13-09 Bottom Length - 13-11, 13-10.5, 13-10 Top width - 8-7.5, 8-8, 8-7 Bottom width - 8-7, 8-8, 8-7.5 Depth - 2-0, 1-11.5, 1-10, 1-11, 1 -10.5, 1-11.75, 1-11
in staad pro. modelling for a parallel scissors chord truss, when i assigned roller support i.e fixwd but with all Fx, FZ, Mx, My and Mz release except Fy... the analysis results " in stability at a joint, with direction Mx or My..what could be the reason...anyone please explaing
How much Tolerance factors like 1. brick work 2.plaster 3.painting 4.floor tiling 5.wall tiling 6.shuttering 7.concreting 8.steel
how much of quantity of material required for execution of one cubic meter of random rubble masonry in 1:3 cement mortar
Explain how you can turn off the display for dimension in CAD?
pls give me ans to ACT formula cube testing porpuse
How much quantity of cement and sand required for the inlining of 610mm dia MS pipe 8.7mm thk.Inlining thickness is 10mm and CM ratio is 1:1.5.
how can can column be corrected when the design is not safe ? is the increasing the clearcover a solution?
What type of tensile strength is handling by crank in beam? Thanks.
Find out Cutting Length of Steel for Right angle Triangle? Where Opposite Side 4m, Adjacent side 6m. (Assume cover 40mm)
Can we use Polystyrene as a Bitumen modifier !! if so is it a good MS research topic ? and what type of laboratory tests will be conducted during Research work ??
