Interested to Buy Any Domain ? << Click Here >> for more details...
what are the difference between protection class CT and
Class PS CT
- 13 Answers
- 34206 Views
- I also Faced
- E-Mail Answers
Answer Posted / satheesh
the saturation point between the ps is higher than
protection class & metering.and the accurracy is also
higher then protection CT. It has highly efficient so it is
mosly used in sofasticated protections (DIFF,DISTANCE )
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
How to Calculate the Fault Level of Electrical Installation
what is negative and zero impedance in 3 phase induction motor ??
why -48 volts dc used in telecommucation
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
if you are in a software company,then why do you want to come in a core company like sail, ntpc(where lots of trouble like tension but you have a good life in a it company) ?
before transformer oil dielectric strenght tests are taken the oil should be allowed to settle to remove option 1 air bubbles 2 gasses 3 contamination 4 water
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
State kirchoff voltage law?
WHAT IS DEAD END IN PROTECTION?
i have interview in Pepsi company what type of question will ask please send the question and answeer
EXPLIAN THE IMPORTANCE OF POLY PHASE CIRCUIT.
What current flows in the transformer primary when its secondary is open?
what is mean by restructuring power system?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
