Interested to Buy Any Domain ? << Click Here >> for more details...
What is the expansion of RADAR? How it works?
- 7 Answers
- 32306 Views
- RasGas, I also Faced
- E-Mail Answers
Answer Posted / kannoth shimna
Radio Detection and Ranging.it works on the principle of
reflection of wave.
| Is This Answer Correct ? | 17 Yes | 5 No |
Post New Answer View All Answers
What are the interlocks we have to check during the start up of LP/HP compressor?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
How process line mpm calculation is done?
how many types of viberation transmitter and how to calibrate and where use of vibration transmitter
Explain an adaptive / self-tuning controller’s major draw card.
How to Calibrate Radar Level Transmitter in Field
Can anybody tell me which type of question are asked in the interview for the FORMULATION(Pharma) as a instrumentation engineer, & question in building managment system.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
What is the differerence between hysterisis and linearity.
How does your previous experience relate to the job you are applying for ?
NSV type probe stands for
What is modbus?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Explain signal isolator
In Safe Guarding test what means by "Failed to Danger" ?
