Answer Posted / k.prakashchandra
earthing is always grounding and grounding is not earthing
always.
Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
How are load losses and no-load losses measured at site in a DG set?
What is an order of a system.
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
Operation of isolators.
1. transformer design formula ? 2. how to calculate the primary turns and secondry turns ? 3. core types ? 4. how to find the primary current and secondry current ? 5. how to calculate the stacking factor ? 6. range of fulx density ?
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
What is different between Difnit time and instatous over current relay
defination of transistor controlled series capacitor
Difference between control junction box (cjb) and power junction box(pjb)?
Differentiate between ideal and non-ideal voltage sources?
wheather the size of windings in motor and generator are the same
Draw a block diagramof Three UPS systems connected in Parallel mode?
Can any body tell me the different types of LT cables & their application.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?