Answer Posted / hemant babu
the vehicle will run but it will harm the engine as auto
ingnition temperature of petrol(246 degree) is higher than
diesel(210 degree),so petrol engine can be run on diesel
but diesel engine cant be run on petrol
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
What are the minerals needed to make or build a car?
pls send the technical question paper
Explain what are the thermal conductivity properties of brass?
What is meant by direct heat exchanger [or] open heat exchanger?
hii sir. how will CAE/CFD courses useful to B.tech freshers? is this courses useful to getting job in automobile industry? plz give some advise...
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
How to operate soot blower boiler and economizer?
with the aid of schematic and block diagram describe the control system involved in a student passing a control system engineering examination.use standard terminologies and specify all the system component involved.
What is forced convection?
whats the coloring code of a air to open or a air to close valve?
what is the use of choper motor in pyrometer ?
Define reynolds number [re].
What is the thermal efficiency of a diesel engine?
Where can i see model papers for NLC graduate engineer test and RRB section engineer test
What does Nominal size in a valve means like NG6,NG10 etc
