Interested to Buy Any Domain ? << Click Here >> for more details...
how to measure level under ground tank ? which type of
transmitter very accuracy ?
- 3 Answers
- 9250 Views
- Biocon, I also Faced
- E-Mail Answers
Answer Posted / haridass
To measure the ground level tank (sump level), the RADAR
level transmitter is the best.
The ULTRASONIC level transmitters also can be used.
At low cost the PURGE TYPE LEVEL MEASUREMENT can be done
for the liquid/slurry level measure.
| Is This Answer Correct ? | 24 Yes | 1 No |
Post New Answer View All Answers
what is the reset offset and control system in instrumentation
Pl send the model question paper of mahagenco account officer post
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
How to Calibrate Ultrasonic Level Transmitter in field
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
I need control valve ISA hand book. Is there any site to download that big book containing all the pages. Written by Paul Friedmann
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
What is instrumentation instrumentation engineering?
what is the difference between magnetic flow meter and mass flowmeter
why I need valve guard and whats different between guard and positioner ??
sir, give me placement papers and interview quistion of birla group company of copper.
What types of Instrumentation Related Questions can an Interviewer ask in a Telephonic Interview ?
What is Span Error
What is the reason PT speed not incresed in gas turbine?
