how to calibrate transmitter online (in running plant)please
explain correct procedure
Answer Posted / ali
dear brother i need correct procedure in detail my question is . HOW CALIBRATE TRANSMITTER IN ONLINE (RUNING PLANT)I MEAN WE DO NOT ISOLATE TRANSMITTER OR SHOULD ISOLATE IT THEN NEXT SHOULD I CHANGE IN CONTROLLER OR DCS SYS. WHAT TO DO.??
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
If we increase only P what will be controller action ?
How to work togather like sov,limit switch,proxy switch and booster in xv
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
how to relay switch sense the fault?
Q- What are the application in which PNP transistor is preferred over NPN ?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
what is sil (safety integrity level
can anyone guide me how to get any of the previous year GAIL question papers? are they available? 0n 2nd august i have to take the written test.