Interested to Buy Any Domain ? << Click Here >> for more details...
say a transformer is designed for 33/11kv step down with
ratio 0.33 for load 1 mva. if am giving 11kv as a input
that same transformer what will happen to its o/p voltage.
and whether it can be operated for 500kva
- 4 Answers
- 6023 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Yes
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
I Need standard operation procedure(SOP)for 500kva Oil type transformer oil filtration & Procedure for IR value checking.
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
Which power will flow first if we switch on a motor Active or Reactive? How?
Can any body tell me about INNER SHUNT COMPOUND MOTOR diagram?
In diesel generator how AVR get voltage to excitation. And basic diagram DG EXCITATION CIRCUIT.
is all the servo motors having brake?please specify which servo motors having brake for stop on position and which are not.
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
I completed iti in2004 I was worked in A grade contractor can I get c licence
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
howmany electrician should maintain for a 1000 kva used plant... in kerala..
What must be the distance between the Earth pit which are grounded from two different sources. Example: Distance between the earth pit for LV Panel-1 & 2
orifice sizing how done, checking & selection
what is the maximum permissible limit value of leakage current and leakage counter reading to replace lightining arrester?
