Interested to Buy Any Domain ? << Click Here >> for more details...
I find that underground strip-armoiured,4core,LT PVC cables
in an earthed power distribution sytem are occasionly found
in charred condition-with no trace of it except ash. Is
this because of no proper earth connection/continuity
(giving rising to high armour resistance)in the joint
enroute or because of insufficient capability (again due to
high armour resistance)of cable-armour to carry fault
current or due to neglected /unprotected overloading of the
cable or due to high armour currents caused by power thefts
where only phase(s) are unauthorisely tapped & at the point
of poer consumption earth terminal is established by
burring underground a not so good earthing rod (or using an
underground water pipe for the purpose)
- 1 Answers
- 4100 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Do not earth both the ends of armour ,only one end is to be
earthed
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why we permissive overreach in distance protection.where it is applicable to use in long r short lines
What is meant by full pitched winding?
Why strting torqe high in inducation motor?
What is the purpose of using busbar mounting fuse?
Please explain me abt PQ diagaram in the power sector.
How to work meggar?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
Control wiring of a dol starter for forward and backward
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
Is there chopping current in resistive circuit
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what should be the ideal gauge of wire (In sq mm) for different loads in Ampere?
how to measure dc earth leakage current?
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
