Interested to Buy Any Domain ? << Click Here >> for more details...
WHY ARE THE LT GENERATORS SOLIDLY EARTHED WHILE THE HT
GENERATORS ARE EARTHE THROUGH NGR OR NGT??
- 3 Answers
- 8649 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
Electrical energy is directly is utilised in case of small
alternators whereas it is not so in HT generators.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
what is the difference between torque induced and torque load?compare them with respect to dc motor?
reason of diode failure in alternator
Which cable is use for rtcc control panel
What should be the values of settling time, peak time, steady state error, overshoot, rise time, MPOS (Maximum percent over shoot) to keep the system in transient state, to keep the system in steady state ?
please send the last 5 years {{{JUNIOR ENGINEER - ELECTICAL, ELECTRONICS RRB CHENNAI and secundrabad}}} TECHNICAL question papers TO MY EMAIL ID dinesh100701@gmail.com
In EDO ACBs what is a purpose of closing coil and motor, what is the operation of these devices are they inetconnected. means if we give supply to motor and by BCS we charge Closing coil,what exact is operation is and how it charge a spring of ACB. Sir if anybody has an wiring diagram please send me the link to operate and EDO breaker.
What is instrumental error?
What effect does a very low impedance have on the Voltage regulation? On the short-circuit current?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
what is the effect of vector group while phase sequence of a generator changes,whether the vector group changes or not
how ct burden,magnetising current,ratio and knee point voltage are related & derived
For RCD (Residual current device) Icu is defined. How i can find Ics for them?
how many load we can take for lighting
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
