Why Trasformers rated in KVA
- 13 Answers
- 16182 Views
- College School Exams Tests, HAL, Oil and Gas Jobs, I also Faced
- E-Mail Answers
Answer Posted / pushpendra
Due to losses in transformer ,Because Full load loss(copper
loss)in term of current & No load loss(iron loss)is in term
of vollage .
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is dynamo?How it works and what is the function of dynamo in a DG.
How to calulate Locked rotor amper(LRA) for compressor type motors?
What is a parabolic signal?
why magnet has north and south poles only why not east and west and why we are considering as north and south poles? why cant we consider as east and west?
How to design the no. of ceiling fans required in 5mtr X 10 mtr X 3 Mtr hight room?
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
How many types of circuit loads are there in a common electrical circuit?
Define open loop control system.
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
Is vtg is controlled by the resistor? if else how much?
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
What are the advantages and disadvantages of negative feed back?
Why colled 440V to 3-phase supply.
how can we design robots
