1)Why potential transformer primary site grounded?
2)can be loop between neutral & body for grounding?
3)What is the difference between ELCB &RCCB?
4)Why we use iron core in transformer insted of wooden core?
5)what is the principle of excitation?
6)Why we test the core balance test for transformer?
7)what is creepage?What is the creepage length for
insulators at different voltages?
8)How much type of relays used for differential protection
of generator,transformer & busbar protection?
- 5 Answers
- 11536 Views
- I also Faced
- E-Mail Answers
Answer Posted / neeraj pati
1. Here the HV or LV of THE TRANSFORMER is not concerned.
The star side of the transformer is grounded. i.e the
neutral of the star side is grounded for detecting the
earth fault current in case of earth fault in the protected
zone of the transformer.
2. No the body and the neutral should be grounded
separately . because huge fault current can flow in the
body and other auxilliary protection in case of a earth
fault.
8. Differential protection relays are used. eg ABB
SPAD346C1,c2,c3, Siemens 7ut612 etc .
| Is This Answer Correct ? | 3 Yes | 2 No |
Post New Answer View All Answers
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
When is lag lead compensator is required?
magnetizer priciple
In 90 kva alternator that produce the output voltage is 115(p-n),200(p-p) at 1500 rpms means what ampere it produced ?
Write down the design procedure of commutaj.
If I want to buy a new Xformer for my plant what are the main parameter will I need to check?
What is big transformer parts and their function ? Ty
What are the advantage of free wheeling diode in a full wave rectifier?
What is the significance of integral controller and derivative controller in a pid controller?
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
What is capacitance?
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
tan delta equation test on alternators
