why do we prefer a 3-phase delta connected load rather than
star connected?
- 4 Answers
- 6619 Views
- I also Faced
- E-Mail Answers
Answer Posted / nithi
for a same power rating the current in delta connected load
is 1.732 times lesser than the star connected load (heat
loss is less) &also if one phase get opened the other two
phases will serve the load i.e.good stability.but in safety
point of view, star connected load is better than delta
load.because earthing can be done without the help of
earthing transformer.
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Hello to all, Please someone can send me HPCL ELECTRICAL Engg. Sample papers to me? Its urjent....my email address is.... raviasiapacific@gmail.com
Write down the name of 2 lady Bir Pratin of Bangladesh
hi, i have 3x200KVA and 2 x 80KVA UPS with battery bank of 150AH 68Nos. and 100AH 204Nos., i need to install AC either ductable or PAC type, so can you help me to calculate heat load and capacity of the AC to install.
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
salam,hi, i need to know what the spesification of 300amp msb...
what is consequences of neutral and earth connect?
What is the effect of pi controller on the system performance?
What is the dependency of stiffness on load angle??
Can clean earth cable be considered as low current cable
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
what is the value of combined earthing in general electrical circiut?
What is the difference between security constraint unit commitment and security constraint optimal power flow?
