Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gagan kumptar gua
when a motor take high current the wiring of the winding
will be burnt becouse H is proposnal to square of
current.it happens due to loose connection or over load and
change in frequency of voltage.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
IN 1000kva transformer where the oil and winding temperature sensors is connected
do we use links in a dc circuit?if so what s its use in it?
How you calculate the repturing capacity of a HRC fuse
What is a fuse? How does it work? What are materials used?
how was your last weekend.
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Explain about how is it working Earth fault'relay and wahts the resistance value of earth bed
what is mean by drives?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
What are the factor to be consider for CT selection in 132kV substation?
which is the most advanced form of SF6 BREAKER?Can we use other gases to quench the arc?
What are the two major types of control system?
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
Why efficiency of generator is higher than motor at a particular load?
What are the weight of 800KV DA,DB and DC type tower ?
