why do we prefer a 3-phase delta connected load rather than
star connected?
- 4 Answers
- 6620 Views
- I also Faced
- E-Mail Answers
Answer Posted / vitthal upare
In star speed of motor is very low with low amp.
and in delta motor running with its normal rated speed with
rated amp.
So generally for motor starting purpose star used and
afterthat its change over to delta
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
how to size H.T & L.T Panel ?
describe the Operation of induction generators from bus bars
where lt & ht capacitor used
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
What is the count of hvdc transmission lines in india?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
how to calculate cable size in diffrent loads?
Hello sir, pls send me hpcl technical test papers .i am. Appearing for the exam.
How to know the Max. current caring capacity of the cable by its size ?
what & how to check the lightning arrester
what is a pilot wiring and whys that called a pilot wiers
WHAT IS THE SIGNIFICANCE OF VECTOR GROUPS IN TRANSFORMER? WHAT WILL BE EFFECT WHEN PHASE DISPLACEMENT CHANGES IN TRANSFORMER?WHAT IS THE NEED TO BE PHASE SHIFT CHANGE BETWEEN THE PRIMARY AND SECONDARY WINDING
Why do we require transformer with less specific weight if supply frequency is increased?
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
