Interested to Buy Any Domain ? << Click Here >> for more details...
what would happen if u assume to insulate all the overhead
lines and no insulators....??do you think it to b an
advantag or a disadvantage??justify.
- 3 Answers
- 5881 Views
- I also Faced
- E-Mail Answers
Answer Posted / shailesh tankni
Providing insulation to over head transmission line
would be beneficial, as it may provide more safety, and
comparatively the insulators used may be of small capacity
as required when uninsulated wire are used.
But the disadvantage would be that the it is not cost
effective as the transmission line is of large length and a
large amount of money will be required to insulate it and
also maintainance cost increases as the insulation may
deteriorate after a specific period of time.
And the complexity of sag calculation increases and
pole loading capacity required will also be high
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How does PLC work for sychronising of Two or more DG sets?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
in dc series motor if field wdg is shorted then
describe the phenomena of vacuum interruption in C.B
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
What is the effect of positive feedback on the stability of the systems?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
Draw a circuit diagram in which if button is open we can use socket and bulb as a series test circit and if button is close than simple we can use socket as any load purpose.
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
DG cranking voltage?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
what is current check gurd relay?
hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx
1)how to reduce the value of tan delta of trasformer and CB,bushing,CT&PT,CVT ? 2)how to reduce the resistance of CB contact and its operating time? 3)plz.....send me the project report on conditioning and monitoring of substation equipment on my email id (gusaiyogendra03@gmail.com)
What is the function of interposing current transformer?
