what would happen if u assume to insulate all the overhead
lines and no insulators....??do you think it to b an
advantag or a disadvantage??justify.
- 3 Answers
- 4915 Views
- I also Faced
- E-Mail Answers
Answer Posted / guest
i think that insulating overhead lines without the help of
insulators would prove to b quite less advantageous.as we
see that an insulator provides a manifold add onn to the
ovrhead line like providing support to the conductors.also
if we provide o/h conductors with insulating coatings,the
effective weight would be increased resulting in a greater
sag and more aeoline viberations and galloping....
please post the most ralavent answer of yours for this
questions...rsvp
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
15hp motor wound by 0.9mm & 0.95mm magnet wire. at no load test it draw 4.2A current. Another motor with same condition draw 9.2A current. How can that occur? pls help
Transformer diagram mention each parts ?
What will happen if i replace a inductive proximity switch with photo sensor in a machine?
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
in single phase converter, the no.of scr's conducting during overlap a)1 b)2 c)3 d)4
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
how maney type tempereture measurement ?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
is there any current and voltage drop on liquid resistance starter water/soda tank ?
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how we can calculate the efficiency of a diesel generator ?
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
I am going to appear for the RRB Chennai junior Engineer online exam. Please send me the previous exams question papers (also solved) to my mail id: rrkhandhar@yahoo.com
