Interested to Buy Any Domain ? << Click Here >> for more details...
if transmission voltage expressed as the multipple of form
factor(1.11)........11,33,66,220 etc......then why
madakkathara substation(kerala) voltage is 400kv..not 440.....?
- 2 Answers
- 7532 Views
- KSEB, I also Faced
- E-Mail Answers
Answer Posted / dharmendra goyal
it is true ,but the reason behind this is that there are
more bulky and large rated equipment are required for
transmission, which are costly and not suitable for
economical consideration.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
What is meant by celling voltage & current in excitor ?
What is the difference between UPS & inverter ? which UPS is better and whos got the edge ? what is the difference between & inverter ? which UPS is better and whos got the edge 12 V , 24 V , 36 V etc what are the advantages of 12 V, 24 V , 36 V etc and what are the disadvantages of 12 V, 24 V, 36 V etc thanks
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
How to Decide(calculate) Bush bar size for copper and aluminiam ?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
Why we use ups battery and dsdb battery in thermal power plant
i want to know that what is the eligibility critaria for ongc exam?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
What are m circles?
What is error of a measurement?
Pl. give me checklist for installation & commissioning of machine tool.
What is star-delta transformer?
Mention the disadvantages of low power factor? How can it be improved?
