Interested to Buy Any Domain ? << Click Here >> for more details...
what will be the effect on a bulb in case its connetion is
change from live and neutral to live and ground???
1) in case of single phase AC supply
2) in case of DC supply.......???
- 1 Answers
- 4180 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
If the earthing is good ,the bulb will burn at almost full
phase voltage in case of AC.In DC ,the same if one polarity
is earthed, but if the ground potential is at +/- zero volt
by midpoint earthing,the bulb gets the half the full
voltage.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how can i get the formula to find out the cable size if i know the load of main fuse protection.
What are the types of instrument transformer?
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
What are the material used for inductance coil?
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
Why you want to join non technical field when you are an engineer?
What is MSL designation of a motor and same may be provided in details.
Can anyone provide with a SLD for HT panel installation for a 33KV line and distribution end has three 1.5MV transformers. Is it suitable to use OCB or VCB and also provide me the suitable rating and its connection diagram.
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
What determines the thickness of the lamination or stamping?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
In aerodynamic turbines which element is NOT there a.stator b.compressor c. Fuel intake system d.fans
What is meant by positive and negative feedback?
what are the difference between PLC and embedded
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
