Answer Posted / lokesh thota
Pumping means if breaker is close & give close command (electrical or manual) to it,spring will discharge & charge again. To prevent this pumping anti pumping feature is required,which in turn will help to restrict unnecessary operations of breaker mechanisms.
| Is This Answer Correct ? | 9 Yes | 9 No |
Post New Answer View All Answers
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
How can a equal potential zone be carried out in conductors?
what is spadar bar .why I use in DC generator.
What is polar plot?
Why delta star trformers are used for lighting loads?
can i able to get bhel previous exam question paper?
What is a fuse? How does it work? What are materials used?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
what is the need to express current and voltage in rms value? rms value is also called as effective value,what is effective value?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
Can you tell me more about pu systems (per unit systems )calculation in large power systems? how to get the base for voltage and power in generator, transformator and transmission lines?
hai iam arunkumar. i have applied for an section enginner in rrb. i want lat 5 years solved question papers. if u have please sedn it to arun30682@gmail.com
power transmission pole used one support , that only for support or earthing
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
