Answer Posted / dinesh (techie.dinesh@gmail.co

first, KVA*PF=KW

WE know that, power = VI
so KW=VI

KVA*PF=VI

so, I= (KVA*PF)/ V

What is the use of iron core in a transformer?

1178

---

what will happen if i connect 12 volt battery with 24 volt battery charger.

1943

---

There is any especial requirement for motor to drive through with VFD?

2654

---

why we use single core 630mm2 cable for transformer secondary side

974

---

WHAT IS IEC? & WHAT IS BENEFIT TO PRODUCT FROM IEC?

2181

---

we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.

1973

---

what are all types of cross section in AC cables?

2369

---

why the perameters of secondary circuit are more important then that of the primary circuit of induction motor?

1966

---

what can be the causes of capacitor start motor having a higher current that its actual

2004

---

My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I -    is the value of AC fault current. t -    is the operating time of disconnecting device in seconds. K –  is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.

1933

---

How can we increase fuel-power ratio of any DG set?

1858

---

How many size of cable required for a 300m long and 30kw inductive lode

1354

---

why output is out of phase in case of common emitter?

2185

---

What is Negative Potential Bias

2355

---

Define unilateral circuit?

1319

---