what is reactive power (MVAR) and how it is control? how it
is generate in powerplant?
- 1 Answers
- 14503 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The reactive power on generator can be controlled only if
it is connected to grid/network.If you make the terminal
voltage higher than of grid ,gen will draw inductive power
(lagging pf) and the vice versa.Usually generators are run
at 0.92 to 0.98 lagging pf for system stability.
| Is This Answer Correct ? | 19 Yes | 7 No |
Post New Answer View All Answers
please send me jindal previous aptitude and technical question and answer.my email id is deep_raj@live.com
i have gear oil pump with single phase motor.some time its motor starts running in reverse direction rather than forward direction...whats the reason behind this issue. 1- either capacitor is week? 2- or winding is week?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
Is there any guideline say about display of earthing value near to earth pit
how to test and calculat the head and discharge in borewell compressor
RESPECCTED SIR/MADAM- I AM PRERING FOR SECTION ENGINEER (ELECTRICAL) RRB CHANDIGARH PLEASE SEND ME SOME PREVIOUS YEAR QUESTION PAPER OR MODEL PAPER.MY EXAM IS ON (30- NOVEMBER 2008).I AM VERY THANKFUL TO YOU. FROM- HARENDRA SINGH YADAV
what is the difference between electrical choke and electronic choke?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
In electrical what is earth(ground)connection, wht is the importance of it, why it is recomended to maitain below 3VAC between Neutral and earthspecially in PLC used machines?
How we calculate DC inducation moter Amp? Sir pls give me formula......
how to set relay setting? and example calculation...
What facility we get after CT secondary earthing and how?
What current position are you holding in your current company?
How many types of faults are there in 3 phase power system?
tell me some type of questions throught which i can prepare for exam and do my best
