Interested to Buy Any Domain ? << Click Here >> for more details...
how do you calculate IKW(consumption per TR) in HVAC?
- 27 Answers
- 149548 Views
- Aircon, CBRE, Cipla, Clivet, Cushman Wakefield, JLL, Sodexo, Voltas, Wipro, I also Faced
- E-Mail Answers
Answer Posted / vivek namdeo
IKW/TR = consume power in k.w./generated chiller TR
| Is This Answer Correct ? | 59 Yes | 8 No |
Post New Answer View All Answers
What is Negative Potential Bias
state the working principle of incondenscent tube?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
With a phasor diagram show the effect of increasing the field current of a generator supplying a constant real power and connected to a grid system.
how calculate gd2 of ht motors
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
What the main causes of transient interruptions on Over-Head Distribution Lines?
working principle a.v.r. ?
Define what is difference between fuse and breaker?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
List examples of voltage source?
