what is the working principle of soft-starter & how it
diff. from VFD ?????????
- 5 Answers
- 20925 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / ram sajeevan patel
A softstarter is replica of a star-delta starterin which
starting current is controlled by reducing voltage using ac
voltage controller for smooth starting.As Ac voltage
controllers are not suitable for speed control.So,soft
starters are mainly used for starting purpose only.(since
in Ac voltage controller,frequency is fixed,only voltage
has to be varied.Also,It produces predominant harmonics
into the system.
Where as by using VFD,we can control both voltage and
frequency,so speed control is possible above and below Ns.
| Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
What are the Formula of computing Back up Time of 500kVA UPS with 4 Battery Banks, each bank composed of 43 pcs of Batteries 12V150Ah. How to compute the Back up Time of UPS? We have also 3X500kVA UPS running in Parallel same composition as I write above.
On what principle electric motor works?
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
sir, Is their any measuring unit of knoking? please explian?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
Has someone here done a sizing for a generator (3 phase), its for a pumping station. If you have an example for standby/duty and both running (I) star delta (ii) Soft Starter.
Whether 3 phase induction motorwith 100 hp capacity , Amp 160 for which sensitive earth fault relay , type CTUM 15 can be used?
what are the range of memory address in plc for L&T lx7 4A
how to check regenerative load in drived motor
what is the difference between RMS & TRUE RMS VOLTAGE
What is the formula to find out two phase active & reactive power
What is routh hurwitz stability criterion?
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
