Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / su
power factor is the cosine of the angle between voltage
phasor and current phasor.
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
Explain difference between stand by earth fault and residual earth fault protection?
What is the power requirement of tamil nadu for one month?
Wind mill
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
how many safety really of DG sets.
I have 4 busbar of 1000 ampere. we use 4 busbar to make 4000 ampere in one phase.my problem is that when we applied 60% load on that then busbar produced high noise.what is the reason of that and how can i minimize that noise.
I want formula to calculate cable size as per load given in length & amp. I searched many sites but didn't right answer. Please reply me asap.
what is high - pot test. what's its use?????
What is quadrantal symmetry?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
why occ characteristics of generator is also called as magnatization characteristics ?
how to check regenerative load in drived motor
what is magnetizing and demagnetizing current in generator and motor?
