Interested to Buy Any Domain ? << Click Here >> for more details...
what is the use of starter in tube light?and what it
contains
- 12 Answers
- 50475 Views
- L&T, RRB, I also Faced
- E-Mail Answers
Answer Posted / santhosh kumar .k.m.
it is only used for starting purpose.it is used to help the
choke to produce self induction.
| Is This Answer Correct ? | 7 Yes | 5 No |
Post New Answer View All Answers
what are different types of electrical windings? i know the distributed winding ,concentrated winding etc but i want some detailed information, in what condition we will use distributed,concentrated windings what are the difference between them which is best, how induced emf changes by using different types of windings 20 hours ago - 1 week left to answer
What is pi controller?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What are the main advantages of generalized error co-efficients?
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
Is any generator is developed which is operated with out diesal or other expensive source?
how point on wave controller works.
What is Faraday's law
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
Sir,In our company there are 3 caterpillar make(capacity:(1) 3.3KV,2.5MW(2)3.3KV,2.5MW & (3)3.3KV,1.9MW) & 1 deutz make (capacity:11KV,3.8MW)gas engines utilised,all are running in paralell. There are three transformer utilised,(1) 6.25MVA,3.3KV/22KV,Impedence voltage:6.7% used for two generator,both are 2.5MW(2)5.5MVA,3.3KV/22KV,Impedence voltage:7.2% used for one generator of 2.5MW & (3) 5.5MVA,11KV/22KV,Impedence voltage:7.8% used for one generator of 2.5MW.all generator breakers capacity of 1250Amps. Sir,I want the details of fault level calculation of generator,transformer individually & for whole system. If you require any information from me.feel free for contact me sir.pl.send the answer of my question as the earliest as possible.
how to calculate the size of the HT cable
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
What are the types of excitation system?
