Answer Posted / bala_vlsi

U Can select 1600 A breaker for incoming of D.G source
and u can refere cable calouge and select the suitable
cable for 1500A THAT TIME U SHOULD CONSIDER VOTAGE DROP
CALCULATION FOR THE SELECTED CABLE .

either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?

1827

---

What is the armature mmf in a D.C machine?

1180

---

What is meant by reverse polarity and how it can be fixed?

1197

---

WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?

2148

---

how many joint can done in HT line and what is life of the joint

2165

---

How to Decide(calculate) Bush bar size for copper and aluminiam ?

2069

---

How to calculate energy stored in an inductance?

1063

---

hello everybody. what does an abnormal stator winding impedance or dc resistance show? thanx

1854

---

In parallel operation time both NGR’s close or not close if both close what will happen

3677

---

What are the advantages and disadvantages of negative feed back?

1079

---

There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?

2261

---

EXPLAIN THE TERMS "INTEREST AND DEPRECIATION" AS APPLIED TO ECONOMICS OF POWER GENERATION.

2259

---

how to calculate micom relay earth falt time and current sertting

2405

---

what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY

2147

---

If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive

1743

---