what is the difference between current voltage transformer
and current transformer and where it is used?
- 2 Answers
- 4105 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravindra gupta
The CVT is meant for voltage measurement in HVAC system.
Apart from this CVT is used for PLCC communication also.
However current transformer is used for current measurement
in HVAC system.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Define phase lag and phase lead?
what kn of disc is used in 33kv,132kv,220kv,400kv,800kv transmission line
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
operation of protection relay watchdog contact?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
What is the de rating factor of cable? What is the importance of the de rating factor in cable select
I Have 3 Phase 10 KW AC Alternator i found one phase weak, so what will be the reason & what action shouls i take to rectify the same.
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
Name the component u would expect to find in a switchgear assembly?
How will calculate losses in an multi core Aluminium LT cable of different sizes & upto what length we can use a LT Cable ?
Dear all, how we select the cable size according to current with or without including different correction factor , is there any direct method for sizing of cable...
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
what is the difference between electrical choke and electronic choke?
