What is mean by single phasing used in distribution of electricity in rural area of maharashtra state?

Answer Posted / k.prakashchandra

To reduce the peak load on the system, single phase supply
is made available in rural areas for single phase domestic
and commercial use only

Is This Answer Correct ?    1 Yes 5 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

We have two APFC panels in same station. I need how to connect CT in two APFC panels.can we take one CT in series connection or two separate CTs.

989


How to set the relay,,??

1633


In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.

1299


what is the difference between surge protection capacitor and surge arrestor

1821


This is urgent!! What is a Thyristor-based 3-ways selector switch with Zero crossing control? how does it operate and where is it mostly found in a system?

1586






What will happen if we introduce negative feedback to a control system that uses a positive feedback?

686


how to protect motor in dol starter having capacity of 30 hp.40 hp?

2770


pls tel me the electric train traction motors name plate details like rpm,torue,voltage,amps,watts..ect..

1571


What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?

1582


how to Select Lighting arrester? What r the parameters to be considered for the selection of Lighting arrester ?

1197


which mm cable should be used for 1.hp immersible pump motor for the distance of 330 metres?

1257


what is high - pot test. what's its use?????

1618


I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?

1744


What is rotating magnetic field?Discuss elaborately.

2159


How do we calculate over and under frequency tolerance from generator data?

1015