Interested to Buy Any Domain ? << Click Here >> for more details...
why voltage rating not mention at HPSV or HPMV lamps?
- 2 Answers
- 6764 Views
- OPS, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
High voltage is required to strike the arc inside lamp at
the starting point and once the arc is struck and lamp is
illuminated ,the voltage across the lamp is zero.It is the
ballast which has to control the current and it requires
voltage rating and not the lamp
| Is This Answer Correct ? | 7 Yes | 2 No |
Post New Answer View All Answers
In EB metering we face problem kva jump even in no load condition.can any one help to control this
list the advantages of RCCB over other circuit breakers?
how to calculate earth fault relay current and CBCT ratio
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
What OPGW is better than Microwave or PLCC???
How two nos. 130 kw D.C motor get synchronise using D.C drive.
how is the testing of an REF relay? what are the test REF circuit having?
Why do we need a separate control desk & PLC control panel in Boiler plant or coal handling plant? Can we provide cost effective Control desk cum PLC panel. Is there is an specific need for control desk.. kindly advice.
Dear sir my name Ankit i m Diploma holder present working in Welspun Corp ltd Anjar as Asst.engg (salary 14400/month ctc) i Would like to change my company also i have selected in ford India pvt ltd Sanand as trainee Tech with salary 12000/month so please suggest me for changing my job hope for *ve response
what is the current setting for different relay protection for transformer .
WHAT CAUSED THRESHOLD VOLTAGE TO EXIST?
what is the need of starter in tube light and what type of starter is used in that?
what is mean by dual digital protection in the relay field?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
