HOW TO CALCULATE THE CABLE SIZE FOR POWER CABLE, CONTROL
CABLE AND INSTRUMENT CABLE
- 2 Answers
- 10300 Views
- CA, I also Faced
- E-Mail Answers
Answer Posted / naresh chandra jha
it depend upon connecting load and voltage . cable size is
calculated by = (IT^(o.5))/k
where I= max. fault current
T=time to withstand fault current
K=conductor constant , for alluminium k=0.094
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
What is different between resistance grounding system and resistance earthing system?
what can be the causes of capacitor start motor having a higher current that its actual
What is Control & Relay Panel? And Remote Control Center?
why the neutral line is not giving shock to us if we touch it ?
why using transformer and thyristor switch in 3 phase apfc panel
List examples of current sources?
what is destructive and non-destructive testing of welding
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
what are the safety measures of induction motor?
What is the complete procedure of erection of electrical panel in industry
state the working of discharge lamp?
what happens to the water pump if ground water level is slowly decreasing?our water pump is varying from no-load full-load due to this problem
Single line digram for 11 kV to distribution use go,la and do
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
What will happen if we on 200kvr capacitor bank(11kv in bus)If there is low load on transformer (1.5 mva 33/11 kv)
