Interested to Buy Any Domain ? << Click Here >> for more details...
How Size of Busbar is determined for a particular load.
- 2 Answers
- 7745 Views
- I also Faced
- E-Mail Answers
Answer Posted / vishnu.a
load is the major thing to determine busbar..
aluminium bus bar
Amps=1.2x area.............. if busbar size is 50x6 means
we can allow 360 amps
copper bus bar
approximately amps=area
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
HOW WE CALCULATE CURRENT IF THERE ARE NOT PRESENT ANY AMMETER OR MULTIMMETER??????
Is vtg is controlled by the resistor? if else how much?
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
In hydel power plants, L.A's, S.C's are placed inside the control panel boards. what is the purpose? [already the total body was earthed to ground.]
What is the difference between earthing,ground&nutral?
electrical
What are dependent sources?
On a 3 winding transformer YNynd11, how do you apply REF protection to the Delta tertiary winding that is supplying auxiliaries to a substation?
Please nybody say, weather the result of Bharat Oman is declared or not? Probable date of declare???????
What is the effect of pi controller on the system performance?
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
how to calculate the distance relay faulty zone?pls explain?
How to calculate LT XLPE CABLE for 11 kv / 433 v , 1000 kva oil type transformer system?
how to calculate the settings for shaft ct protn in hydro generators
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
