Interested to Buy Any Domain ? << Click Here >> for more details...
IF 5000amp current on LT 440V. then how much it will draw
amp on HT 11KV side
- 10 Answers
- 28834 Views
- I also Faced
- E-Mail Answers
Answer Posted / santosh soni
power is transfer for receiving end are same so all power is
transfer another side
5000*440=I*11000
I=200amp
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
why we used dc supply for field in dg set
What happen to generator if i have unbalanced load?
What is the difference between PLC and Embeded system
Define what is difference between fuse and breaker?
What is the tube exial fan?
sir iam from electrical and electronics branch ,can i appear for the hpcl offline requirtment? if yes please mail me on vikram_raju25@yahoo.co.in
difference between crane drive and line drive.
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
what will happen when the dc supply is given to the capacitor?
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
