Interested to Buy Any Domain ? << Click Here >> for more details...
what is radar type level transmitters and its basic
principle and how to calibrate it
- 4 Answers
- 20880 Views
- ABB, Inovonz, I also Faced
- E-Mail Answers
Answer Posted / vsraj_ece
radar level txr as a geiger counter and the source is emits
the radio waves into the vessel it contains some liquids the
ionised radio electrons move to the chargable ends as a
measurement unit if low liquids are in vessel means higher
electrons move to measurement unit.
| Is This Answer Correct ? | 10 Yes | 6 No |
Post New Answer View All Answers
Why upper weighing limit of electronics balance is 90% of the total weighing capacity?
How is flow measured in square root?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
how many pulses are required by a ac induction servo motor of 4 poles with 50 Hz frequency to rotate by 1 degree?
Hi Friends i need Electronics&Instrumentation Engg question papers for BARC written test by coming 20th May 2008 pls post ur use full info to kkumarei@gmail.com. Or for suggestions pls give one missed call to 9962122264
In turbine, what does term CDP, NI, NH, HSSOC, means
Why not come out analog output in ABB EL3020 when display show correct value
Why all the drains(Gland sealing,ESV,Casing inlet etc) are directly connected to the flash tank instead of hotwell of the condensor in the power plant? My Email Id:naba02222@gmail.com
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
why is not useing in boiler skin thermocople
plz you help about Que paper of mahagenco previous your,any model paper relad to it{maharastra power genration}
What is the basic difference between Modbus and CAN Open Protocols
what is the working principal of pribe
Identification of ss fittings, pilot valves, relief valve.
