i have 2 motor of same rating. on no load condition one
motor take 1.6A but other motor is taking 4.8A. what is the
reason of this. please explain with proof.
- 8 Answers
- 8463 Views
- Ambuja, UltraTech, I also Faced
- E-Mail Answers
Answer Posted / b.b. singh
one motor has connected in star then it taking 1.6A &
another is connected in delta so it taking 4.8A.
| Is This Answer Correct ? | 16 Yes | 1 No |
Post New Answer View All Answers
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
how we findout a ignater is faulty or not?
why in the three pin plug all 3 pins are cutted ?
why we need to us lenz's law for synchornous motor
wish of these transformer uses oil?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
Difference between field rheostat and armature rheostat.
How to find out damper winding failure for synchronous machine?
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
What are dcs and plc?
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
What are the advantages of the three-phase motor over single phase motor?
wat is d diffr btw shunt coil and trip coil in VCB?
can u tell me the promotion from oiller to enginer
How to test REF relay testing for LV panel as per Kahramaa standard?
