a 3 phase slip ring induction motor is wound for 4 poles on
stator and 6 poles on rotor; when 3 phase balanced voltage
source at 50 hz is applied to motor it will run at
a)1500rpm b)1000rpm c)750 rpm d)zero rpm
- 13 Answers
- 21584 Views
- Essar, PSPCL, PSTCL, I also Faced
- E-Mail Answers
Answer Posted / sayem
1000
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
How many types of protection relays are there based on the characteristic?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
What is current divider rule (cdr)?
State angle criterion.
how to decide choke rating for drive?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
Why GRR starts from 60% of motor speed why not less than 60%?
What is the capacity of the Fastners 12mm?
What is the gross weight to copper ratio in slip ring induction motor of 4000 HP,6.6 kv, 372amp, 992 rpm GE motor.
what is a composite error in current transformers, why occurs & in which it will occur i.e, either metering ct/ protection ct
Starting current of a 10 HP induction Motor is ______ time’s full load current.
What are the material used for resistor?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
Dear friends, i would like to know that what is the exact function of 'exciter winding' & 'aux winding' in Alternator?
