Interested to Buy Any Domain ? << Click Here >> for more details...
Can the same motor be operated in both direction ?
- 12 Answers
- 17798 Views
- I also Faced
- E-Mail Answers
Answer Posted / p.k.chadhar
In case of dc motors, change the direction of either
field current or the armature current. if u change both ,the
motor will run in the same direction as before.
For ac machines(3 phase) just by changing the phase connection
we can make the motor to run in opposite direction.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What are the special cables required for explosion proof wiring?
What is the Basic Difference bitween Long Shunt Connection and Short Shunt Connection in DC Generator?
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.
I need bhel previous year quetion papers for electrical engineering department.I searched but i could not find out
distribution transformer de-rating formula on over limit iron losses
What is current divider rule (cdr)?
why asa method ZPF method is more accurate than ASA method?
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
which network topology offers the greatest level of tolerance?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How many points does a Circuit can have?
We need to current density & short circuit calculation at 65kA for aluminium & copper busbar.
How time response of the system is divided?
