why we use to always generate power below 16kv.why not at
higher voltage?
- 3 Answers
- 5154 Views
- I also Faced
- E-Mail Answers
Answer Posted / r.praveen durai
Generating Higher Voltage is Possible and more efficient as per Losses, But for that much of voltage high cost and heavy devices and Electrical equipments are needed for utilization like Transformers and their auxiliary device, Circuit breakers, Isolators, Surge Arrestors, Lightning equipments etc.. so its not easy and effective as in business mind so critical value and sustainable value of voltage is in generation.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
how to select fuse rating for a 3-phase motor ???
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
how to test power transformer.YNd11
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING) I O (current operating)?
Mention how NPN and PNP transistor works?
From reading, Under voltage relay used also as phase sequence relay now, Why I use under voltage and phase sequence relay in the same circuit (ATS)?
State ohm’s law?
what is the acceptable limit value for Desolve Gas Analysis/
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
What is the working principle of MIG welding? and its out put Voltage?
wheather the size of windings in motor and generator are the same
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
why all the feeders are designed in a particular manner ... is there any reason for that???
